Configuring The Ftp Template - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
8. (Optional.) Specify the HTTPS
operation type.
9. (Optional.) Enter raw request
view.
10. (Optional.) Enter or paste the
content of the HTTPS request
for the HTTPS operation.
11. (Optional.) Return to HTTPS
template view.
12. (Optional.) Specify the source
IP address for the probe
packets.
13. (Optional.)
expected data.
14. (Optional.)
expected status codes.

Configuring the FTP template

A feature that uses the FTP template performs the FTP operation. The operation measures the time
it takes the NQA client to transfer a file to or download a file from an FTP server.
Configure the username and password for the FTP client to log in to the FTP server before you
perform an FTP operation. For information about configuring the FTP server, see Fundamentals
Configuration Guide.
To configure the FTP template:
Step
1. Enter system view.
2. Create an FTP template
and enter its view.
3. Specify the URL of the
destination FTP server.
Command
operation { get | post |
raw }
raw-request
N/A
quit
•
•
Configure the
expect data expression
[ offset number ]
Configure the
expect status status-list
Command
system-view
nqa template ftp name
url url
IPv4 address:
source ip ip-address
IPv6 address:
source ipv6
ipv6-address
122
Remarks
By default, the HTTPS operation type is
get, which means obtaining data from
the HTTPS server.
If you set the HTTPS operation type to
raw, use the raw-request command to
configure the content of the request to
be sent to the HTTPS server.
This step is required for the raw
operation.
Every time you enter the raw request
view, the previously configured request
content is removed.
This step is required for the raw
operation.
By default, the HTTPS request content
is not specified.
The system automatically saves the
configuration in raw request view before
it returns to HTTPS template view.
By default, the packets take the primary
IP address of the output interface as
their source IP address.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
probe packets can be sent out.
By default, no expected data is
configured.
By default, no expected status code is
configured.
Remarks
N/A
By default, no FTP templates exist.
By default, no URL is specified for the
destination FTP server.
Enter the URL in one of the following
formats:
•
ftp://host/filename.
•
ftp://host:port/filename.