Path Jitter Operation Configuration Example - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to internal error: 0
Failures due to other errors: 0
# Display the history records of the DLSw operation.
[DeviceA] display nqa history admin test1
NQA entry (admin admin, tag test1) history records:
Index
1
The output shows that the response time of the DLSw device is 19 milliseconds.

Path jitter operation configuration example

Network requirements
As shown in
Device A to Device B and Device C.
Figure 49 Network diagram
NQA client
10.1.1.1/24
Device A
Configuration procedure
# Assign IP addresses to interfaces, as shown in
# Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
# Execute the ip ttl-expires enable command on Device B and execute the ip unreachables
enable command on Device C.
# Create a path jitter operation.
<DeviceA> system-view
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type path-jitter
# Specify 10.2.2.2 as the destination IP address of ICMP echo requests.
[DeviceA-nqa-admin-test1-path-jitter] destination ip 10.2.2.2
# Configure the path jitter operation to repeat every 10000 milliseconds.
[DeviceA-nqa-admin-test1-path-jitter] frequency 10000
[DeviceA-nqa-admin-test1-path-jitter] quit
# Start the path jitter operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the path jitter operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1
# Display the most recent result of the path jitter operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Response Status
19 Succeeded
Figure 49, configure a path jitter operation to test the round trip time and jitters from
10.1.1.2/24
Device B
Time
2011-11-22 10:40:27.7
10.2.2.2/24
Device C
Figure 49. (Details not shown.)
145