Configuring The Snmp Operation - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
6. (Optional.)
source IP address for UDP
packets.
7. (Optional.)
source port number of UDP
packets.
8. (Optional.) Set the payload
size for each UDP packet.
9. (Optional.)
payload fill string for UDP
packets.
10. (Optional.) Set the number of
UDP packets sent in one
UDP jitter operation.
11. (Optional.) Set the interval
for sending UDP packets.
12. (Optional.) Specify how long
the NQA client waits for a
response from the server
before
response times out.
NOTE:
Use the display nqa result or display nqa statistics command to verify the UDP jitter operation.
The display nqa history command does not display the UDP jitter operation results or statistics.

Configuring the SNMP operation

The SNMP operation measures the time for the NQA client to get a response packet from an SNMP
agent.
To configure the SNMP operation:
Step
1. Enter system view.
2. Create an NQA operation
and enter NQA operation
view.
3. Specify the SNMP type and
enter its view.
4. Specify
address of SNMP packets.
Command
Specify the
source ip ip-address
Specify the
source port port-number
data-size size
Specify the
data-fill string
probe packet-number
packet-number
probe packet-interval interval
probe packet-timeout timeout
it regards the
Command
system-view
nqa
operation-tag
type snmp
the destination
destination ip ip-address
entry admin-name
101
Remarks
be the same as the port number of
the listening service on the NQA
server.
By default, the packets take the
primary IP address of the output
interface as their
address.
The source IP address must be
the IP address of a local interface,
and the interface must be up.
Otherwise, no UDP packets can
be sent out.
By default, no source port number
is specified.
The default setting is 100 bytes.
The default payload fill string is
the hexadecimal
00010203040506070809.
The default setting is 10.
The default setting
milliseconds.
The default setting
milliseconds.
Remarks
N/A
By default, no NQA operations exist.
N/A
By default, no destination IP address
is specified.
source IP
number
is 20
is 3000