Tcp Half Open Template Configuration Example - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Figure 53 Network diagram
NQA client
10.1.1.1/16
Device A
Configuration procedure
1. Assign IP addresses to interfaces, as shown in
2. Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3. Configure Device B:
# Enable the NQA server.
<DeviceB> system-view
[DeviceB] nqa server enable
# Configure a listening service to listen to the IP address 10.2.2.2 and TCP port 9000.
[DeviceB] nqa server tcp-connect 10.2.2.2 9000
4. Configure Device A:
# Create TCP template tcp.
<DeviceA> system-view
[DeviceA] nqa template tcp tcp
# Specify 10.2.2.2 as the destination IP address.
[DeviceA-nqatplt-tcp-tcp] destination ip 10.2.2.2
# Set the destination port number to 9000.
[DeviceA-nqatplt-tcp-tcp] destination port 9000
# Configure the NQA client to notify the feature of the successful operation event if the number
of consecutive successful probes reaches 2.
[DeviceA-nqatplt-tcp-tcp] reaction trigger probe-pass 2
# Configure the NQA client to notify the feature of the operation failure if the number of
consecutive failed probes reaches 2.
[DeviceA-nqatplt-tcp-tcp] reaction trigger probe-fail 2

TCP half open template configuration example

Network requirements
As shown in
provide the TCP service for Device A.
Figure 54 Network diagram
NQA client
10.1.1.1/16
Device A
Configuration procedure
1. Assign IP addresses to interfaces, as shown in
2. Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
10.2.2.2/16
IP network
Figure 54, configure a TCP half open template for a feature to test whether Device B can
10.2.2.2/16
IP network
NQA server
Device B
Figure 53. (Details not shown.)
NQA server
Device B
Figure 54. (Details not shown.)
151