Configuring Access Control Rights; Configuring Ntp Authentication - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Configuring the multicast server
Step
1. Enter system view.
2. Enter interface view.
3. Configure
operate in multicast server
mode.

Configuring access control rights

Step
1. Enter system view.
2. Configure the right for peer
devices to access the NTP
services on the local device.
Before you configure the NTP service access control right to the local device, create and configure
an ACL associated with the access control right. For more information about ACL, see ACL and QoS
Configuration Guide.

Configuring NTP authentication

This section provides instructions for configuring NTP authentication.
Command
system-view
interface
interface-number
•
the device to
•
Command
system-view
•
•
interface-type
Configure the device
operate in multicast server
mode:
ntp-service
multicast-server
[ ip-address
[ authentication-keyid
keyid | ttl ttl-number
version number ] *
Configure the device
operate in multicast server
mode:
ntp-service
multicast-server
ipv6-multicast-address
[ authentication-keyid
keyid | ttl ttl-number ] *
Configure the right for peer
devices to access the IPv4
NTP services on the local
device:
ntp-service access { peer |
query | server
synchronization
ipv4-acl-number
Configure the right for peer
devices to access the IPv6
NTP services on the local
device:
ntp-service ipv6 { peer |
query | server
synchronization }
ipv6-acl-number
16
Remarks
N/A
Enter the interface for sending
NTP multicast message.
to
]
By default, the device does not
operate in multicast server mode.
|
After you execute the command,
the device receives NTP multicast
to
messages from the specified
interface.
ipv6
Remarks
N/A
|
}
By default, the right for peer
devices to access
services on the local device is
peer.
|
acl
the NTP