Icmp Template Configuration Example - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

224.0.0.0/24
255.255.255.255/32
The output shows that the static route does not exist, and the status of the track entry is negative.

ICMP template configuration example

Network requirements
As shown in
from Device A to Device B.
Figure 51 Network diagram
NQA client
10.1.1.1/24
10.3.1.1/24
Device A
Configuration procedure
# Assign IP addresses to interfaces, as shown in
# Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
# Create ICMP template icmp.
<DeviceA> system-view
[DeviceA] nqa template icmp icmp
# Specify 10.2.2.2 as the destination IP address of ICMP echo requests.
[DeviceA-nqatplt-icmp-icmp] destination ip 10.2.2.2
# Set the probe timeout time to 500 milliseconds for the ICMP echo operation.
[DeviceA-nqatplt-icmp-icmp] probe timeout 500
# Configure the ICMP echo operation to repeat every 3000 milliseconds.
[DeviceA-nqatplt-icmp-icmp] frequency 3000
# Configure the NQA client to notify the feature of the successful operation event if the number of
consecutive successful probes reaches 2.
[DeviceA-nqatplt-icmp-icmp] reaction trigger probe-pass 2
# Configure the NQA client to notify the feature of the operation failure if the number of consecutive
failed probes reaches 2.
Direct 0
Direct 0
Figure 51, configure an ICMP template for a feature to perform the ICMP echo operation
Device C
10.1.1.2/24 10.2.2.1/24
10.3.1.2/24 10.4.1.1/24
Device D
0 0.0.0.0
0 127.0.0.1
10.2.2.2/24
10.4.1.2/24
Device B
Figure 51. (Details not shown.)
149
NULL0
InLoop0