Voice Operation Configuration Example - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

[DeviceA-nqa-admin-test1-udp-tracert] no-fragment enable
# Set the maximum number of consecutive probe failures to 6.
[DeviceA-nqa-admin-test1-udp-tracert] max-failure 6
# Set the TTL value to 1 for UDP packets in the start round of the UDP tracert operation.
[DeviceA-nqa-admin-test1-udp-tracert] init-ttl 1
# Start the UDP tracert operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the UDP tracert operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1
# Display the most recent result of the UDP tracert operation.
[DeviceA] display nqa result admin test1
NQA entry (admin admin, tag test1) test results:
Send operation times: 6
Min/Max/Average round trip time: 1/1/1
Square-Sum of round trip time: 1
Last succeeded probe time: 2013-09-09 14:46:06.2
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to internal error: 0
Failures due to other errors: 0
UDP-tracert results:
TTL
1
2
# Display the history records of the UDP tracert operation.
[DeviceA] display nqa history admin test1
NQA entry (admin admin, tag test1) history records:
Index
1
1
1
1
1
1

Voice operation configuration example

Network requirements
As shown in
Device A and Device B.
Figure 47 Network diagram
NQA client
10.1.1.1/16
Device A
Hop IP
3.1.1.1
10.2.2.2
TTL Response
2 2
2 1
2 2
1 1
1 2
1 1
Figure 47, configure a voice operation to test jitters, delay, MOS, and ICPIF between
10.2.2.2/16
IP network
Receive response times: 6
Time
2013-09-09 14:46:03.2
2013-09-09 14:46:06.2
Hop IP Status
10.2.2.2 Succeeded
10.2.2.2 Succeeded
10.2.2.2 Succeeded
3.1.1.1 Succeeded
3.1.1.1 Succeeded
3.1.1.1 Succeeded
NQA server
Device B
141
Time
2013-09-09 14:46:06.2
2013-09-09 14:46:05.2
2013-09-09 14:46:04.2
2013-09-09 14:46:03.2
2013-09-09 14:46:02.2
2013-09-09 14:46:01.2