Configuring The Ssl Template - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
4. (Optional.) Specify the
FTP operation type.
5. Specify an FTP login
username.
6. Specify an FTP login
password.
7. (Optional.) Specify the
name of a file to be
transferred.
8. Set the data transmission
mode.
9. (Optional.) Specify the
source IP address for the
probe packets.

Configuring the SSL template

IMPORTANT:
This feature is available in Release 1121 and later.
A feature that uses the SSL template performs the SSL operation to measure the time required to
establish an SSL connection to an SSL server.
Before you configure the SSL template, configure the SSL client policy. For information about
configuring SSL client policies, see Security Configuration Guide.
To configure the SSL template:
Step
1. Enter system view.
2. Create an SSL template
and enter its view.
3. (Optional.) Specify the
destination IP address of
the operation.
Command
operation { get | put }
username username
password { cipher | simple }
sting
filename filename
mode { active | passive }
•
IPv4 address:
source ip ip-address
•
IPv6 address:
source ipv6 ipv6-address
Command
system-view
nqa template ssl name
•
IPv4 address:
destination ip ip-address
•
IPv6 address:
destination
ipv6-address
123
Remarks
When you perform the get operation,
the file name is required.
When you perform the put operation,
the filename argument does not take
effect, even if it is specified. The file
name for the
determined by the filename command.
By default, the FTP operation type is
get, which means obtaining files from
the FTP server.
By default, no FTP login username is
specified.
By default, no FTP login password is
specified.
This step is required if you perform the
put operation.
This configuration does not take effect
for the get operation.
By default, no file is specified.
The default mode is active.
By default, the packets take the primary
IP address of the output interface as
their source IP address.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
probe packets can be sent out.
Remarks
N/A
By default, no SSL templates exist.
By default, no destination IP address is
configured.
ipv6
put operation is