HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual page 28

Step
4. Configure the key as a
trusted key.
5. Associate the specified
key with a passive peer.
To configure NTP authentication for a passive peer:
Step
1. Enter system view.
2. Enable
authentication.
3. Configure an
authentication key.
4. Configure the key as a
trusted key.
NTP authentication results differ when different configurations are performed on active peer and
passive peer. For more information, see
configuration is performed does not make any difference.)
Command
[ acl ipv4-acl-number | ipv6 acl
ipv6-acl-number ] *
ntp-service
authentication-keyid keyid
•
Associate the specified key with a
passive
ntp-service
{ ip-address
[
vpn-instance-name
authentication-keyid keyid
•
Associate the specified key with a
passive
ntp-service
{ ipv6-address | peer-name }
[
vpn-instance-name
authentication-keyid keyid
Command
system-view
NTP
ntp-service authentication enable
•
Release
ntp-service
authentication-keyid
authentication-mode
{ cipher | simple } value
•
Release
NTP
ntp-service
authentication-keyid
authentication-mode
{ hmac-sha-1 | hmac-sha-256 |
hmac-sha-384 | hmac-sha-512 |
md5 } { cipher | simple } string
[ acl ipv4-acl-number | ipv6 acl
ipv6-acl-number ] *
ntp-service
authentication-keyid keyid
Table
19
reliable
peer:
unicast-peer
| peer-name }
vpn-instance
]
peer:
ipv6 unicast-peer
vpn-instance
]
1111:
keyid
md5
1121 and later:
keyid
reliable
3. (N/A in the table means that whether the
Remarks
By default, no authentication
key is configured as a trusted
key.
N/A
Remarks
N/A
By default, NTP authentication is
disabled.
By default, no NTP authentication
key is configured.
By default, no authentication key
is configured as a trusted key.