Configuring The Udp Template - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step

Configuring the UDP template

IMPORTANT:
This feature is available in Release 1121 and later.
A feature that uses the UDP template performs the UDP operation to test the following items:
•
Reachability of a specific port on the NQA server.
•
Availability of the requested service on the NQA server.
In UDP template view, you can specify the expected data to be returned. If you do not specify the
expected data, the UDP operation tests only whether the client can receive the response packet from
the server.
The UDP operation requires both the NQA server and the NQA client. Before you perform a UDP
operation, configure a UDP listening service on the NQA server. For more information about the UDP
listening service configuration, see
To configure the UDP template:
Step
1. Enter system view.
2. Create a UDP template
and enter its view.
3. (Optional.) Specify the
destination IP address of
the operation.
4. (Optional.) Specify the
destination port number
for the operation.
5. (Optional.) Specify the
payload fill string for the
probe packets.
6. (Optional.)
payload
probe packets.
7. (Optional.) Specify the
source IP address for the
probe packets.
8. (Optional.) Configure the
expected data.
Command
"Configuring the NQA
Command
system-view
nqa template udp name
•
IPv4
destination
ip-address
•
IPv6
destination
ipv6-address
destination
port-number
data-fill string
Set the
size for the
data-size size
•
IPv4
source ip ip-address
•
IPv6
source
ipv6-address
expect
[ offset number ]
server."
Remarks
N/A
By default, no UDP templates exist.
address:
By default, no destination address is
ip
specified.
The destination address must be the same
address:
as the IP address of the listening service
ipv6
configured on the NQA server.
By default, no destination port number is
specified.
port
The destination port number must be the
same as the port number of the listening
service on the NQA server.
The default payload fill string is the
hexadecimal
00010203040506070809.
The default setting is 100 bytes.
By default, the packets take the primary IP
address: address of the output interface as their
source IP address.
address:
The source IP address must be the IP
ipv6
address of a local interface, and the
interface must be up. Otherwise, no probe
packets can be sent out.
By default, no expected data is configured.
data expression
If you want to configure this command,
make sure the data-fill command is
119
Remarks
effect.
number