HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual page 173

•
Use a monitor port only for port mirroring, so the data monitoring device receives only the
mirrored traffic.
•
A mirroring group must contain only one monitor port.
•
A monitor port can belong to only one mirroring group.
Configuring the monitor port for a remote destination group in system view
Step
1. Enter system view.
2. Configure the monitor port
for the specified remote
destination group.
Configuring the monitor port for a remote destination group in interface view
Step
1. Enter system view.
2. Enter interface view.
3. Configure the port as the
monitor port for the specified
remote destination group.
Configuring the remote probe VLAN for a remote destination group
When you configure the remote probe VLAN for a remote destination group, follow these restrictions
and guidelines:
•
Only an existing static VLAN can be configured as a remote probe VLAN.
•
When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
mirroring exclusively.
•
Configure the same remote probe VLAN for the remote groups on the source and destination
devices.
To configure the remote probe VLAN for a remote destination group:
Step
1. Enter system view.
2. Configure the remote probe
VLAN
remote destination group.
Assigning the monitor port to the remote probe VLAN
Step
1. Enter system view.
Command
system-view
mirroring-group
monitor-port
interface-number
Command
system-view
interface
interface-number
mirroring-group
monitor-port
Command
system-view
mirroring-group
for the specified
remote-probe vlan vlan-id
Command
system-view
group-id
interface-type
interface-type
group-id
group-id
164
Remarks
N/A
By default, no monitor port is
configured for a
destination group.
Remarks
N/A
N/A
By default, a port does not act as
the monitor port for any remote
destination group.
Remarks
N/A
By default, no remote probe VLAN
is configured for a
destination group.
Remarks
N/A
remote
remote