HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual page 62

Table 13 Log field description
Field
Prefix (information type)
PRI (priority)
Timestamp
Sysname (host name or
host IP address)
%% (vendor ID)
vv (version information)
Module
Level
Mnemonic
Source
Content
Table 14 Timestamp precisions and configuration commands
Item Destined to the log host
Precision Seconds
Command
used to set the
info-center timestamp loghost
timestamp
format
Description
A log to a destination other than the log host has an identifier in front of the
timestamp:
•
An identifier of percent sign (%) indicates a log with a level equal to or
higher than informational.
•
An identifier of asterisk (*) indicates a debug log or a trace log.
•
An identifier of caret (^) indicates a diagnostic log.
A log destined to the log host has a priority identifier in front of the timestamp.
The priority is calculated by using this formula: facility*8+level, where:
•
facility is the facility name. Facility names local0 through local7
correspond to values 16 through 23. The facility name can be configured
with the info-center loghost command. It is used to identify log sources on
the log host, and to query and filter the logs from specific log sources.
•
level ranges from 0 to 7. See
levels.
Records the time when the log was generated.
Logs sent to the log host and those sent to the other destinations have different
timestamp precisions, and their timestamp formats are configured with different
commands. For more information, see
The sysname is the host name or IP address of the device that generated the
log. You can use the sysname command to modify the name of the device.
Indicates that the information was generated by an HPE device.
This field exists only in logs sent to the log host.
Identifies the version of the log, and has a value of 10.
This field exists only in logs that are sent to the log host.
Specifies the name of the module that generated the log. You can enter the
info-center source ? command in system view to view the module list.
Identifies the level of the log. See
levels.
Describes the content of the log. It contains a string of up to 32 characters.
Identifies the source of the log. It can take one of the following values:
•
IRF member ID.
•
IP address of the log sender.
Provides the content of the log.
53
Table 6 for more information about severity
Table 14 and Table 15.
Table 6 for more information about severity
Destined to the console, monitor
terminal, log buffer, and log file
Milliseconds
info-center timestamp