Configuring The Tcp Operation - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
5. (Optional.)
source
packets.
6. (Optional.)
source IP address of SNMP
packets.
7. (Optional.)
community name for the
SNMP
operation uses the SNMPv1
or SNMPv2c agent.

Configuring the TCP operation

The TCP operation measures the time for the NQA client to establish a TCP connection to a port on
the NQA server.
The TCP operation requires both the NQA server and the NQA client. Before you perform a TCP
operation, configure a TCP listening service on the NQA server. For more information about the TCP
listening service configuration, see
To configure the TCP operation:
Step
1. Enter system view.
2. Create an NQA operation
and enter NQA operation
view.
3. Specify the TCP type and
enter its view.
4. Specify
address of TCP packets.
5. Specify the destination port
of TCP packets.
6. (Optional.)
source IP address of TCP
packets.
Command
Specify the
port of SNMP
source port port-number
Specify the
source ip ip-address
Specify the
community read { cipher |
operation if the
simple } community-name
"Configuring the NQA
Command
system-view
nqa
operation-tag
type tcp
the destination
destination ip ip-address
destination port port-number
Specify the
source ip ip-address
server."
entry admin-name
102
Remarks
By default, no source port number is
specified.
By default, the packets take the
primary IP address of the output
interface as their source IP address.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
SNMP packets can be sent out.
By default, the SNMP operation uses
community name public.
Make sure the specified community
name is the same as the community
name configured on the SNMP agent.
This command is available in Release
1121 and later.
Remarks
N/A
By default, no NQA operations exist.
N/A
By default, no destination IP address
is specified.
The destination address must be the
same as the IP address of the
listening service configured on the
NQA server.
By default, no destination port number
is configured.
The destination port number must be
the same as the port number of the
listening service on the NQA server.
By default, the packets take the
primary IP address of the output
interface as their source IP address.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no