Performing The Get-Config/Get-Bulk-Config Operation - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

•
If the module name and the submodule name are not provided, the operation retrieves the data
for all modules and submodules. If a module name or a submodule name is provided, the
operation retrieves the data for the specified module or submodule.
•
If the table name is not provided, the operation retrieves the data for all tables. If a table name is
provided, the operation retrieves the data for the specified table.
•
If only the index column is provided, the operation retrieves the data for all columns. If the index
column and other columns are provided, the operation retrieves the data for the index column
and the specified columns.
The <get> and <get-bulk> messages are similar. A <get-bulk> message carries the count and index
attributes. The following is a <get-bulk> message example:
<?xml version="1.0" encoding="UTF-8"?>
<rpc message-id ="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0"
xmlns:xc="http://www.hp.com/netconf/base:1.0">
<get-bulk>
<filter type="subtree">
<top xmlns="http://www.hp.com/netconf/data:1.0"
xmlns:base="http://www.hp.com/netconf/base:1.0">
<Syslog>
</Syslog>
</top>
</filter>
</get-bulk>
</rpc>
Where, the count attribute complies with the following rules:
•
The count attribute can be placed in the module node and table node. In other nodes, it cannot
be resolved.
•
When the count attribute is placed in the module node, a descendant node inherits this count
attribute if the descendant node does not contain the count attribute.
Verifying the configuration
After receiving the get-bulk request, the device returns a response in the following format if the
operation is successful:
<?xml version="1.0"?>
<rpc-reply message-id="100"
<data>
Device state and configuration data
</data>
</rpc-reply>

Performing the get-config/get-bulk-config operation

The get-config and get-bulk-config operations are used to retrieve all non-default configurations,
which are configured by means of CLI and MIB. The <get-config> and <get-bulk-config> messages
can contain the <filter> element for filtering data.
<Logs xc:count="5">
<Log>
<Index>10</Index>
</Log>
</Logs>
xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
255