Configuration Task List - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Figure 2 CWMP message interaction procedure
CPE
(6) HTTP response (GetParameterValues request)
(7) HTTP post (GetParameterValues response)
(8) HTTP response (SetParameterValues request)
(9) HTTP post (SetParameterValues response)

Configuration task list

To use CWMP, you must enable CWMP from the CLI. You can then configure ACS and CPE
attributes from the CPE's CLI, the DHCP server, or the ACS.
For an attribute, the CLI- and ACS-assigned values have higher priority than the DHCP-assigned
value. The CLI- and ACS-assigned values overwrite each other, whichever is assigned later.
This document only describes configuring ACS and CPE attributes from the CLI and DHCP server.
For more information about configuring and using the ACS, see ACS documentation.
To configure CWMP, perform the following tasks:
Tasks at a glance
(Required.)
Configuring ACS
•
(Required.)
attributes
Assigning ACS attributes from the DHCP server

Configuring the preferred ACS attributes from

the CLI
•
(Optional.)
from the CLI
(Optional.) Configuring CPE
•
Configuring ACS authentication parameters
•
Configuring the provision code
•
Configuring the CWMP connection interface
•
Configuring autoconnect parameters
Configuring the periodic Inform feature

Scheduling a connection initiation

Configuring

(1) Open TCP connection
(2) SSL initiation
(3) HTTP post (Inform)
(4) HTTP response (Inform response)
(5) HTTP post (empty)
(10) HTTP response (empty)
(11) Close connection
Enabling CWMP from the CLI
attributes:
Configuring the
Configuring the default ACS attributes
attributes:
the maximum
Remarks
To use CWMP, you must enable CWMP from the
CLI.
preferred ACS
The preferred ACS attributes are configurable
from the CPE's CLI, DHCP server, and ACS.
The default ACS attributes are configurable only
from the CLI.
All CPE attributes are configurable from the CLI
and ACS except for the following attributes:
•
•
•
•
These attributes are configurable only from the
CLI.
number of
207
CWMP connection interface
NAT traversal
Maximum number of connection retries
SSL client policy for HTTPS