Configuring Optional Parameters For The Nqa Template - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

Step
4. (Optional.) Specify the
FTP operation type.
5. Specify an FTP login
username.
6. Specify an FTP login
password.
7. (Optional.) Specify the
name of a file to be
transferred.
8. Set the data transmission
mode.
9. (Optional.) Specify the
source IPv4 or IPv6
address for the probe
packets.

Configuring optional parameters for the NQA template

Step
1. Enter system view.
2. Create an NQA template
and enter its view.
3. Configure a description.
4. Specify the interval at
which the NQA operation
repeats.
5. Specify the probe
timeout time.
6. Specify the TTL for probe
packets.
7. Specify the ToS value in
the IP header for probe
packets.
8. Configure the number of
consecutive successful
probes that lead to a
Command
operation { get | put }
username username
password { cipher | simple }
password
filename filename
mode { active | passive }
•
IPv4 address:
source ip ip-address
•
IPv6 address:
source ipv6 ipv6-address
Command
system-view
nqa template { dns | ftp |
http | icmp | tcp | udp } name
description text
frequency interval
probe timeout timeout
ttl value
tos value
reaction trigger probe-pass
count
135
Remarks
operation, the file name is required.
When you perform the put
operation, the filename argument
does not take effect, even if it is
specified. The file name for the put
operation is determined by the
filename command.
By default, the FTP operation type is
get, which means obtaining files
from the FTP server.
By default, no FTP login username
is specified.
By default, no FTP login password is
specified.
By default, no file is specified.
This step is required if you perform
the put operation.
This configuration does not take
effect for the get operation.
The default mode is active.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface, and
the interface must be up. Otherwise,
no probe packets can be sent out.
Remarks
N/A
N/A
By default, no description is configured.
The default setting is 5000 milliseconds.
If the operation is not completed when the
interval expires, the next operation does
not start.
The default setting is 3000 milliseconds.
The default setting is 20.
The default setting is 0.
The default setting is 3.
If the number of consecutive successful
probes for an NQA operation is reached,