Dns Template Configuration Example; Tcp Template Configuration Example - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

[DeviceA-nqatplt-icmp-icmp] reaction trigger probe-fail 2

DNS template configuration example

Network requirements
As shown in
operation tests whether Device A can perform the address resolution through the DNS server.
Figure 52 Network diagram
NQA client
10.1.1.1/16
Device A
Configuration procedure
# Assign IP addresses to interfaces, as shown in
# Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
# Create DNS template dns.
<DeviceA> system-view
[DeviceA] nqa template dns dns
# Specify the IP address of the DNS server 10.2.2.2 as the destination IP address.
[DeviceA-nqatplt-dns-dns] destination ip 10.2.2.2
# Specify host.com as the domain name to be translated.
[DeviceA-nqatplt-dns-dns] resolve-target host.com
# Set the domain name resolution type to type A.
[DeviceA-nqatplt-dns-dns] resolve-type A
# Specify 3.3.3.3 as the expected IP address.
[DeviceA-nqatplt-dns-dns] expect ip 3.3.3.3
# Configure the NQA client to notify the feature of the successful operation event if the number of
consecutive successful probes reaches 2.
[DeviceA-nqatplt-dns-dns] reaction trigger probe-pass 2
# Configure the NQA client to notify the feature of the operation failure if the number of consecutive
failed probes reaches 2.
[DeviceA-nqatplt-dns-dns] reaction trigger probe-fail 2

TCP template configuration example

Network requirements
As shown in
operation tests whether Device A can establish a TCP connection to Device B.
Figure 52, configure a DNS template for a feature to perform the DNS operation. The
10.2.2.2/16
IP network
Figure 53, configure a TCP template for a feature to perform the TCP operation. The
DNS server
Figure 52. (Details not shown.)
150