Configuring A Monitor Policy By Using Tcl - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
5. (Optional.) Assign a
user role to the policy.
6. (Optional.) Configure
the policy runtime.
7. Enable the policy.

Configuring a monitor policy by using Tcl

Step
1. Edit a Tcl script file
(see Table
2. Download the file to
the device by using
FTP or TFTP.
3. Enter system view.
4. Create a Tcl-defined
policy and bind it to
the Tcl script file.
Write a Tcl script in two lines for a monitor policy, as shown in
Command
action number syslog priority level
facility local-number msg msg
•
Configure
switchover
action number switchover
user-role role-name
running-time time
commit
Command
N/A
21).
N/A
system-view
rtm tcl-policy
tcl-filename
an active/standby
action:
Remarks
The supported Tcl version is 8.5.8.
For more information about using FTP
and
Configuration Guide.
N/A
By default, the system does not have Tcl
policies.
This step enables the Tcl-defined policy.
To revise the Tcl script of a policy, you
policy-name
must suspend all monitor policies first,
and then resume the policies after you
finish revising the script. The system
cannot execute a Tcl-defined policy if
you edit its Tcl script without suspending
policies.
Table
198
Remarks
By default, a monitor policy
contains user roles that its
creator had at the time of policy
creation.
An EAA policy cannot have both
the security-audit user role and
any other user roles.
previously assigned user roles
are automatically removed when
you assign the security-audit
user role to the policy. The
previously
security-audit user
automatically removed when you
assign any other user roles to
the policy..
The default runtime
seconds.
By default, CLI-defined policies
are not enabled.
A CLI-defined policy can take
effect only after you perform this
step.
TFTP, see Fundamentals
21.
Any
assigned
role is
is 20