Configuring The Udp Jitter Operation - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
10. (Optional.) Enter raw request
view.
11. (Optional.) Specify the HTTP
request content.
12. Save the input and return to
HTTP operation view.

Configuring the UDP jitter operation

CAUTION:
To ensure successful UDP jitter operations and avoid affecting existing services, do not perform the
operations on well-known ports from 1 to 1023.
The UDP jitter operation measures unidirectional and bidirectional jitters. The operation result helps
you determine whether the network can carry jitter-sensitive services such as real-time voice and
video services.
The UDP jitter operation works as follows:
1. The NQA client sends UDP packets to the destination port.
2. The destination device time stamps each packet it receives, and then sends the packet back to
the NQA client.
3. Upon receiving the responses, the NQA client calculates the jitter according to the timestamps.
The UDP jitter operation requires both the NQA server and the NQA client. Before you perform the
UDP jitter operation, configure the UDP listening service on the NQA server. For more information
about UDP listening service configuration, see
To configure a UDP jitter operation:
Step
1. Enter system view.
2. Create an NQA operation
and enter NQA operation
view.
3. Specify the UDP jitter type
and enter its view.
4. Specify
address of UDP packets.
5. Specify the destination port
of UDP packets.
Command
raw-request
Enter or paste the content.
quit
Command
system-view
nqa
operation-tag
type udp-jitter
the destination
destination ip ip-address
destination port port-number
Remarks
If you set the HTTP operation type to raw,
configure the content of the HTTP request
to be sent to the HTTP server in raw
request view.
Every time you enter raw request view,
the previously configured content of the
HTTP request is removed.
By default, no contents are specified.
This step is required for the raw
operation.
N/A
"Configuring the NQA
entry admin-name
100
server."
Remarks
N/A
By default, no NQA operations
exist.
N/A
By default, no destination IP
address is specified.
The destination IP address must
be the same as the IP address of
the listening service on the NQA
server.
By default, no destination port
number is specified.
The destination port number must