Ssl Template Configuration Example - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

# Configure the device to upload file config.txt to the FTP server.
[DeviceA-nqatplt-ftp-ftp] operation put
[DeviceA-nqatplt-ftp-ftp] filename config.txt
# Set the username to admin for the FTP server login.
[DeviceA-nqatplt-ftp-ftp] username admin
# Set the password to systemtest for the FTP server login.
[DeviceA-nqatplt-ftp-ftp] password simple systemtest
# Configure the NQA client to notify the feature of the successful operation event if the number of
consecutive successful probes reaches 2.
[DeviceA-nqatplt-ftp-ftp] reaction trigger probe-pass 2
# Configure the NQA client to notify the feature of the operation failure if the number of consecutive
failed probes reaches 2.
[DeviceA-nqatplt-ftp-ftp] reaction trigger probe-fail 2

SSL template configuration example

Network requirements
As shown in
establish an SSL connection to the SSL server on Device B.
Figure 59 Network diagram
NQA client
10.1.1.1/16
Device A
Configuration procedure
# Assign IP addresses to interfaces, as shown in
# Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
# Configure an SSL client policy named abc on Device A, and make sure Device A can use the policy
to connect to the SSL server on Device B. (Details not shown.)
# Create SSL template ssl.
<DeviceA> system-view
[DeviceA] nqa template ssl ssl
# Set the destination IP address and port number to 10.2.2.2 and 9000, respectively.
[DeviceA-nqatplt-ssl-ssl] destination ip 10.2.2.2
[DeviceA-nqatplt-ssl-ssl] destination port 9000
# Specify SSL client policy abc for the SSL template.
[DeviceA-nqatplt-ssl-ssl] ssl-client-policy abc
# Configure the NQA client to notify the feature of the successful operation event if the number of
consecutive successful probes reaches 2.
[DeviceA-nqatplt-ssl-ssl] reaction trigger probe-pass 2
# Configure the NQA client to notify the feature of the operation failure if the number of consecutive
failed probes reaches 2.
[DeviceA-nqatplt-ssl-ssl] reaction trigger probe-fail 2
Figure 59, configure an SSL template for a feature to test whether Device A can
IP network
SSL server
10.2.2.2/16
Device B
Figure 59. (Details not shown.)
155