Configuring Layer 3 Remote Port Mirroring; Layer 3 Remote Port Mirroring Configuration Task List - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
2. Enter interface view.
3. Configure the port as the
egress port for the specified
remote source group.
Configuring the remote probe VLAN for a remote source group
When you configure the remote probe VLAN for a remote source group, follow these restrictions and
guidelines:
•
Only an existing static VLAN can be configured as a remote probe VLAN.
•
When a VLAN is configured as a remote probe VLAN, use the VLAN for port mirroring
exclusively.
•
The remote mirroring groups on the source device and destination device must use the same
remote probe VLAN.
To configure the remote probe VLAN for a remote source group:
Step
1. Enter system view.
2. Configure the remote probe
VLAN
remote source group.

Configuring Layer 3 remote port mirroring

To configure Layer 3 remote port mirroring, perform the following tasks:
•
Create a local mirroring group on both the source device and the destination device.
•
Configure source ports and the monitor port for each mirroring group.
The source and destination devices are connected by a tunnel. If intermediate devices exist,
configure a unicast routing protocol on the intermediate devices to ensure Layer 3 interoperability
between the source and destination devices.
On the source device, perform the following tasks:
•
Configure the ports you want to monitor as the source ports.
•
Configure the tunnel interface as the monitor port.
On the destination device, perform the following tasks:
•
Configure the physical interface corresponding to the tunnel interface as the source port.
•
Configure the port that connects the data monitoring device as the monitor port.

Layer 3 remote port mirroring configuration task list

Tasks at a glance
(Required.) Configuring the source device:
Command
interface
interface-number
mirroring-group
monitor-egress
Command
system-view
mirroring-group
for the specified
remote-probe vlan vlan-id
interface-type
group-id
group-id
167
Remarks
N/A
By default, a port does not act as
the egress port for any remote
source group.
Remarks
N/A
By default, no remote probe VLAN
is configured for a remote source
group.