Snmp Operation Configuration Example - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Min positive SD: 3
Max positive SD: 30
Positive SD number: 186
Positive SD sum: 2602
Positive SD average: 13
Positive SD square-sum: 45304
Min negative SD: 1
Max negative SD: 30
Negative SD number: 181
Negative SD sum: 181
Negative SD average: 13
Negative SD square-sum: 46994
One way results:
Max SD delay: 46
Min SD delay: 7
Number of SD delay: 410
Sum of SD delay: 3705
Square-Sum of SD delay: 45987
SD lost packets: 0
Lost packets for unknown reason: 0

SNMP operation configuration example

Network requirements
As shown in
response from the SNMP agent.
Figure 43 Network diagram
NQA client
10.1.1.1/16
Device A
Configuration procedure
1. Assign IP addresses to interfaces, as shown in
2. Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3. Configure the SNMP agent (Device B):
# Set the SNMP version to all.
<DeviceB> system-view
[DeviceB] snmp-agent sys-info version all
# Set the read community to public.
[DeviceB] snmp-agent community read public
# Set the write community to private.
[DeviceB] snmp-agent community write private
4. Configure Device A:
# Create an SNMP operation.
<DeviceA> system-view
Figure 43, configure an SNMP operation to test the time the NQA client uses to get a
10.2.2.2/16
IP network
Min positive DS: 1
Max positive DS: 79
Positive DS number: 158
Positive DS sum: 1928
Positive DS average: 12
Positive DS square-sum: 31682
Min negative DS: 1
Max negative DS: 78
Negative DS number: 209
Negative DS sum: 209
Negative DS average: 14
Negative DS square-sum: 3030
Max DS delay: 46
Min DS delay: 7
Number of DS delay: 410
Sum of DS delay: 3891
Square-Sum of DS delay: 49393
DS lost packets: 0
SNMP agent
Device B
Figure 43. (Details not shown.)
136