Applying A Poe Profile; Upgrading Pse Firmware In Service - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
2. Create a PoE profile, and
enter PoE profile view.
3. Enable PoE.
4. (Optional.)
maximum PI power.
5. (Optional.)
priority.

Applying a PoE profile

You can apply a PoE profile in system view or PI view. If you perform the operation in both views, the
most recent operation takes effect. To apply a PoE profile to multiple PIs, perform the operation in
system view. If a PoE profile is applied, it cannot be deleted or modified before you remove its
application.
A PoE profile can be applied to multiple PIs, but a PI can have only one PoE profile.
Applying a PoE profile to multiple PIs in system view
Step
1. Enter system view.
2. Apply a PoE profile to one or multiple PIs.
Applying a PoE profile to a PI in PI view
Step
1. Enter system view.
2. Enter PI view.
3. Apply the PoE profile to the interface.

Upgrading PSE firmware in service

You can upgrade the PSE firmware in service in either of the following modes:
•
Refresh mode—Updates the PSE firmware without deleting it. You can use the refresh mode
in most cases.
•
Full mode—Deletes the current PSE firmware and reloads a new one. Use the full mode if the
PSE firmware is damaged and you cannot execute any PoE commands.
If the PSE firmware upgrade fails because of interruption such as a device reboot, you can restart the
device and upgrade it in full mode again. After the upgrade, restart the device manually for the new
PSE firmware to take effect.
To upgrade the PSE firmware in service:
Command
poe-profile profile-name [ index ]
poe enable
Configure the
poe max-power max-power
Configure PI
poe priority { critical | high |
low }
Command
system-view
apply poe-profile
profile-name } interface interface-range
Command
system-view
interface interface-type interface-number
apply poe-profile
profile-name }
229
Remarks
N/A
By default, this function
disabled.
The default maximum PI power is
30000 milliwatts.
The default priority is low.
{ index index
{ index index
is
| name
| name