Configuring Optional Parameters For The Nqa Operation - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

For more information about the ip ttl-expires enable and ip unreachables enable commands, see
Layer 3—IP Services Command Reference.
To configure the path jitter operation:
Step
1. Enter system view.
2. Create an NQA operation and
enter NQA operation view.
3. Specify the path jitter type and
enter its view.
4. Specify the destination address
of ICMP echo requests.
5. (Optional.) Set the payload size
for each ICMP echo request.
6. (Optional.) Specify the payload
fill string
requests.
7. Specify the source IP address
of ICMP echo requests.
8. (Optional.) Set the number of
ICMP echo requests to be sent
in a path jitter operation.
9. (Optional.) Set the interval for
sending ICMP echo requests.
10. (Optional.) Specify how long
the NQA client waits for a
response
before it regards the response
times out.
11. (Optional.) Specify an LSR
path.
12. (Optional.) Perform the path
jitter operation only on the
destination address.

Configuring optional parameters for the NQA operation

Unless otherwise specified, the following optional parameters apply to all types of NQA operations.
The parameter settings take effect only on the current operation.
To configure optional parameters for an NQA operation:
Command
system-view
nqa
operation-tag
type path-jitter
destination ip ip-address
data-size size
for ICMP echo
data-fill string
source ip ip-address
probe
packet-number
probe
interval
probe
from the server
timeout
lsr-path ip-address&<1-8>
target-only
entry admin-name
packet-number
packet-interval
packet-timeout
108
Remarks
N/A
By default, no NQA operations exist.
N/A
By default, no destination
address is specified.
The default setting is 100 bytes.
The default payload fill string is the
hexadecimal
00010203040506070809.
By default, the packets take the
primary IP address of the output
interface as their source IP address.
The source IP address must be the
IP address of a local interface, and
the interface must be up. Otherwise,
no ICMP echo requests can be sent
out.
The default setting is 10.
The default setting
milliseconds.
The default setting
milliseconds.
By default, no LSR path is specified.
The path jitter operation uses the
tracert to detect the LSR path to the
destination, and sends ICMP echo
requests to each hop on the LSR.
By default, the path jitter operation is
performed on each hop on the path
to the destination.
IP
number
is 20
is 3000