Configuring The Dns Template - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step

Configuring the DNS template

A feature that uses the DNS template performs the DNS operation to determine the status of the
server. It is supported in both IPv4 and IPv6 networks.
In DNS template view, you can specify the address expected to be returned. If the returned IP
addresses include the expected address, the DNS server is valid and the operation succeeds.
Otherwise, the operation fails.
Create a mapping between the domain name and an address before you perform the DNS
operation. For information about configuring the DNS server, see Layer 3—IP Services
Configuration Guide.
To configure the DNS template:
Step
1. Enter system view.
2. Create a DNS template and
enter DNS template view.
3. (Optional.)
destination IP address of DNS
packets.
4. (Optional.)
destination port number for
the operation.
5. Specify the domain name to
be translated.
6. Specify the domain name
resolution type.
7. (Optional.) Specify the source
IP address for the probe
packets.
Command
Command
system-view
nqa template dns name
•
IPv4
destination ip ip-address
Specify the
•
IPv6
destination
ipv6-address
Specify the
destination port port-number
resolve-target domain-name
resolve-type { A | AAAA }
•
IPv4
source ip ip-address
•
IPv6
source ipv6 ipv6-address
Remarks
If you execute the reaction trigger
per-probe
probe-pass
times, the most recent configuration
takes effect.
If you execute the reaction trigger
per-probe
probe-fail commands multiple times,
the most recent configuration takes
effect.
The
command is available in Release
1121 and later.
address:
address:
ipv6
address:
address:
116
and reaction
commands multiple
and reaction
reaction trigger per-probe
Remarks
N/A
By default, no DNS templates
exist.
By default, no destination
address is specified.
By default, the destination port
number is 53.
By default, no domain name is
specified.
By default, the type is type A.
A type A query resolves a
domain name to a mapped IPv4
address, and a type AAAA
query to a mapped
address.
By default, the packets take the
primary IP address of the output
interface as their source IP
address.
The source IP address must be
trigger
trigger
IPv6