Fips Compliance; Netconf Configuration Task List; Enabling Netconf Over Soap - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

FIPS compliance

The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for
features, commands, and parameters might differ in FIPS mode (see Security Configuration Guide)
and non-FIPS mode.

NETCONF configuration task list

Task at a glance
(Optional.)
(Optional.)
(Optional.)
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)

Enabling NETCONF over SOAP

NETCONF messages can be encapsulated into SOAP messages and transmitted over HTTP and
HTTPS. After enabling NETCONF over SOAP, you can develop a configuration interface to perform
NETCONF operations.
To enable NETCONF over SOAP:
Step
1. Enter system view.
2. Enable NETCONF over
SOAP.
Enabling NETCONF over SOAP
Enabling NETCONF over SSH
Enabling NETCONF logging
Establishing a NETCONF session
Subscribing to event notifications
Locking/unlocking the configuration
Performing the get/get-bulk operation
Performing the get-config/get-bulk-config operation
Performing the edit-config operation
Saving, rolling back, and loading the configuration
Filtering data
Performing CLI operations through NETCONF
Retrieving NETCONF session information
Terminating another NETCONF session
Returning to the CLI
Command
system-view
•
•
Enable NETCONF over SOAP
over HTTP (not available in
FIPS mode):
netconf soap http enable
Enable NETCONF over SOAP
over HTTPS:
netconf soap https enable
247
Remarks
N/A
By default, NETCONF over SOAP
is disabled.