Configuring The Tcp Template - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
8. (Optional.) Specify the source
port for probe packets.
9. (Optional.) Specify the IP
address that is expected to be
returned.

Configuring the TCP template

A feature that uses the TCP template performs the TCP operation to test whether the NQA client can
establish a TCP connection to a specific port on the server.
In TCP template view, you can specify the expected data to be returned. If you do not specify the
expected data, the TCP operation tests only whether the client can establish a TCP connection to the
server.
The TCP operation requires both the NQA server and the NQA client. Before you perform a TCP
operation, configure a TCP listening service on the NQA server. For more information about the TCP
listening service configuration, see
To configure the TCP template:
Step
1. Enter system view.
2. Create a TCP template
and enter its view.
3. (Optional.) Specify the
destination IP address of
the operation.
4. (Optional.) Specify the
destination port number
for the operation.
5. (Optional.) Specify the
payload fill string for
requests.
6. (Optional.) Specify the
source IP address for the
probe packets.
7. (Optional.) Configure the
expected data.
Command
source port port-number
•
IPv4
expect ip ip-address
•
IPv6
expect ipv6 ipv6-address
"Configuring the NQA
Command
system-view
nqa template tcp name
•
IPv4 address:
destination
ip-address
•
IPv6 address:
destination
ipv6-address
destination
port-number
data-fill string
•
IPv4 address:
source ip ip-address
•
IPv6 address:
source
ipv6-address
expect data expression
[ offset number ]
117
Remarks
the IP address of a local
interface, and the interface must
be up. Otherwise, no probe
packets can be sent out.
By default, no source port
number is specified.
address:
By default, no expected IP
address is specified.
address:
server."
Remarks
N/A
By default, no TCP templates exist.
By default, no destination address is
ip
specified.
The destination address must be the same
as the IP address of the listening service
ipv6
configured on the NQA server.
By default, no destination port number is
specified.
port
The destination port number must be the
same as the port number of the listening
service on the NQA server.
The default payload fill string is the
hexadecimal
00010203040506070809.
By default, the packets take the primary IP
address of the output interface as their
source IP address.
The source IP address must be the IP
ipv6
address of a local interface, and the
interface must be up. Otherwise, no probe
packets can be sent out.
By default, no expected data is configured.
The NQA client performs expect data
number