Configuring The Ftp Template - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

Step
type.
7. Specify the HTTP version.
8. (Optional.) Enter raw request
view.
9. (Optional.) Enter or paste the
content of the GET request for
the HTTP operation.
10. (Optional.) Save the input and
exit to HTTP template view.
11. (Optional.) Specify the source
IPv4 or IPv6 address for the
probe packets.
12. (Optional.) Configure the
expected status codes.
13. (Optional.) Configure the
expected data.

Configuring the FTP template

A feature that uses the FTP template performs the FTP operation. The operation measures the time
it takes the NQA client to transfer a file to or download a file from an FTP server.
Configure the username and password for the FTP client to log in to the FTP server before you
perform an FTP operation. For information about configuring the FTP server, see Fundamentals
Configuration Guide.
To configure the FTP template:
Step
1. Enter system view.
2. Create an FTP template
and enter its view.
3. Specify the URL of the
destination FTP server.
Command
raw }
version { v1.0 | v1.1 }
raw-request
N/A
quit
•
IPv4 address:
source ip ip-address
•
IPv6 address:
source ipv6
ipv6-address
expect status status-list
expect data expression
[ offset number ]
Command
system-view
nqa template ftp name
url url
134
Remarks
is get, which means obtaining data
from the HTTP server.
In the HTTP raw operation, use the
raw-request command to specify the
content of the GET request to be sent
to the HTTP server.
By default, HTTP 1.0 is used.
This step is required for the raw
operation.
Every time you enter the raw request
view, the previously configured
content of the GET request is
removed.
This step is required for the raw
operation.
By default, no contents are specified.
N/A
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
probe packets can be sent out.
By default, no expected status code
is configured.
By default, no expected data is
configured.
Remarks
N/A
N/A
By default, no URL is specified for
the destination FTP server.
Enter the URL in one of the following
formats:
•
ftp://host/filename.
•
ftp://host:port/filename.
When you perform the get