Configuring The Dns Template - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

Step
1. Enter system view.
2. Create an ICMP template and
enter its view.
3. (Optional.) Specify the
destination IPv4 or IPv6
address of the operation.
4. (Optional.) Specify the
payload size in each ICMP
request.
5. (Optional.) Specify the string
to be filled in the payload of
each request.
6. (Optional.) Specify the IP
address of the specified
interface as the source IP
address of ICMP echo
requests.
7. (Optional.) Specify the source
IPv4 or IPv6 address for the
probe packets.

Configuring the DNS template

A feature that uses the DNS template performs the DNS operation to determine the status of the
server. It is supported in both IPv4 and IPv6 networks.
In DNS template view, you can specify the address expected to be returned. If the returned IP
addresses include the expected address, the DNS server is valid and the operation succeeds.
Otherwise, the operation fails.
Create a mapping between the domain name and an address before you perform the DNS operation.
For information about configuring the DNS server, see Layer 3—IP Services Configuration Guide.
To configure the DNS template:
Step
1. Enter system view.
2. Create a DNS template and
enter DNS template view.
3. (Optional.) Specify the
destination IPv4 or IPv6
Command
system-view
nqa template icmp name
•
IPv4 address:
destination ip ip-address
•
IPv6 address:
destination ipv6
ipv6-address
data-size size
data-fill string
source interface interface-type
interface-number
•
IPv4 address:
source ip ip-address
•
IPv6 address:
source ipv6 ipv6-address
Command
system-view
nqa template dns name
•
IPv4 address:
destination ip ip-address
130
Remarks
N/A
N/A
By default, no destination IP
address is configured.
The default setting is 100 bytes.
The default payload fill string is
hexadecimal number
00010203040506070809.
By default, no source IP address is
specified. The requests use the
primary IP address of the output
interface as their source IP
address.
The specified source interface must
be up.
If you configure the source
interface command with the
source ip or source ipv6
command, the most recent
configuration takes effect.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface, and
the interface must be up.
Otherwise, no probe packets can
be sent out.
Remarks
N/A
N/A
By default, no destination