Configuring Optional Parameters For The Nqa Operation - HPE FlexFabric 5700 Series Network Management And Monitoring Configuration Manual

Step
12. (Optional.) Perform the path
jitter operation only on the
destination address.

Configuring optional parameters for the NQA operation

Unless otherwise specified, the following optional parameters apply to all types of NQA operations.
To configure optional parameters for an NQA operation:
Step
1. Enter system view.
2. Create an NQA operation
and enter NQA operation
view.
3. Specify an NQA
operation type and enter
its view.
4. Configure a description.
5. Specify the interval at
which the NQA operation
repeats.
6. Specify the probe times.
7. Specify the probe
timeout time.
8. Specify the TTL for probe
packets.
Command
target-only
Command
system-view
nqa entry admin-name
operation-tag
type { dhcp | dlsw | dns | ftp |
http | icmp-echo | path-jitter
| snmp | tcp | udp-echo |
udp-jitter | udp-tracert |
voice }
description text
frequency interval
probe count times
probe timeout timeout
ttl value
124
Remarks
requests to each hop on the LSR.
By default, the path jitter operation is
performed on each hop on the path
to the destination.
Remarks
N/A
By default, no NQA operation is created.
N/A
By default, no description is configured.
For a voice or path jitter operation, the
default setting is 60000 milliseconds.
For other operations, the default setting is
0 milliseconds. Only one operation is
performed.
If the operation is not completed when the
interval expires, the next operation does
not start.
By default:
•
In the UDP tracert operation, the
NQA client performs three probes to
each hop to the destination.
•
In other types of operations, the
NQA client performs one probe to
the destination per operation.
This command is not available for the
path jitter and voice operations. Each of
these operations performs only one
probe.
The default setting is 3000 milliseconds.
This command is not available for the
path jitter, UDP jitter, and voice
operations.
The default setting is 30 for probe packets
of the UDP tracert operation, and is 20 for
probe packets of other types of
operations.
This command is not available for the