Front Panel Elements - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

2.5 Front Panel Elements

3
No. Front Panel
Element
1 Display
2 Standby button
3 LEDs
Power
Connected
Status
Operating Instructions
Fluorescence Detectors FLD-3100 and FLD-3400RS
1
2
Fig. 5: Front panel view
Function
Shows information about the detector:
- General information upon power up (→ page 55)
- Status screen, depending on the operating mode (→ page 55)
- Various menus, accessible via the menu key (→ page 57)
- Messages (→ page 97)
Switches the detector to Standby mode (the LED is lighted). To cancel
Standby mode and resume operation, press the Standby button again (the
LED is not lighted).
Note: To allow the detector to change the mode, press the Standby button
for at least one second.
The LED is blue when the detector is on.
The LED is green when the detector is controlled by Chromeleon.
The LED is red when an error has been detected, e.g. when the lamp has
failed. In addition, the corresponding message appears on the front panel
display (→ page 97).
The LED is orange, for example, when the detector is booting.
Otherwise, the LED is green.
UltiMate 3000 Series:
Page 21