Configuration Menu - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

UltiMate 3000 Series:
Fluorescence Detectors FLD-3100 and FLD-3400RS

5.3.4 Configuration Menu

The Configuration menu provides information about the detector configuration and allows
you to make the required settings or change the settings.
> Configuration (1..3)
1. Reset to factory defaults
2. Display & soft keys
3. Leak sensor mode
∨
To ...
Reset all important detector settings to the standard settings. In the
Reset to factory defaults? dialog box, select OK to confirm the restore
or select Cancel to keep your settings.
Set the display and function key parameters:
Brightness—sets the screen brightness.
Contrast—sets the screen contrast.
Key sound—sets whether a beep sounds when you select a function
key: On—yes or Off—no.
Key autorepeat—sets whether the keystroke is automatically repeated
when you remain on the key for a longer period, for example, to change
a value quickly (On = yes or Off = no).
Set how you are alerted in case of a leak alarm:
Audible—activates the leak alarm. When a leak is detected, a beep
sounds.
Silent—deactivates the leak alarm. When a leak is detected, a message
appears on the front panel display, but no beep sounds.
Page 62
∧
Select
Fig. 27: Configuration menu
Back
Select ...
Reset to factory defaults
Display & soft keys
Leak Sensor Mode
Operating Instructions