Mains Power Cord; Mains Voltage - Fluke Calibration 5322A Operator's Manual

Mains Power Cord

A mains power cord that will connect to the power receptacles found in the region
to which the Product is shipped is included with each Product.
To prevent possible electrical shock, fire, or personal injury:
•
Use only the mains power cord and connector approved for the
voltage and plug configuration in your country and rated for the
Product.
•
Replace the mains power cord if the insulation is damaged or if
the insulation shows signs of wear.
•
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could cause
death.
•
Do not use a two-conductor adapter or extension cord; this will
break the protective ground connection. If a two-conductor power
cord must be used, a grounding wire must be connected between
the Product ground terminal and a protective earth ground before
connecting the power cord or operating the Product.
After you verify that the line voltage selection switch is set to the correct position,
verify that the correct fuse for that line voltage is installed.

Mains Voltage

To prevent possible electrical shock, fire, or personal injury:
•
Do not put the Product where access to the mains power cord
is blocked.
•
The Product enclosure must be grounded through the
grounding conductor of the power cord, or through the rear
panel ground binding post.
The Product comes with the appropriate line power plug for the country of
purchase. If a different type is necessary, refer to Table 4. They list and show the
mains line power plug types available from Fluke Calibration.
XWWarning
XW Warning
Multifunction Electrical Tester Calibrator
Power Considerations
11