Fluke Calibration 5322A Operator's Manual page 141

[SOUR]:SAF:LIN:CORR (?) <CPD> {OFF | MAN | SCAN | COMP}
Description: This command sets the mode of residual impedance correction.
Parameters: <CPD>
Example: SAF:LIN:CORR MAN Manual correction of residual impedance.
Query: SAF:LIN:CORR?
[SOUR]:SAF:LIN:POL?
Description: Returns the type of test signal generated by the DUT. If not already
selected, it also switches the Product to the Line Impedance
function.
Query: SAF:LIN:POL?
Types are:
Test current is pulse (dc) with positive polarity (POS)

Test current is pulse (dc) with negative polarity (NEG)

Test current is symmetrical (ac) with positive phase (SYMP)

Test current is symmetrical (ac) with negative phase (SYMN)

 Test current is dc with positive polarity (DCP)
 Test current is dc with negative polarity (DCN)
NO is returned when the generated test signal is not valid.
[SOUR]:SAF:LIN:CURR?
Description: This command returns the measured maximum (peak) value of
current flowing through the selected resistance. Maximum value
can be cleared using command SAF:LIN:CLEar. The Product
returns the current value using exponential format. Example:
215 mA is returned as 215.0e-03
Query: SAF:LIN:CURR?
Multifunction Electrical Tester Calibrator
Parameter represents type of
residual impedance correction. If
not already selected, this command
switches the Product into the Line
Impedance function mode.
•
OFF no correction
•
MAN manual residual impedance
correction
• SCAN scanned residual impedance
correction
•
COMP compensated residual
impedance correction
Returns the type of residual correction
mode selected.
Supported SCPI Commands
133