Festo CiA 402 Manual page 149

A Diagnostic messages
Error group 29 SD card
No. Code Message
29-2 7682h SD parameter record error
Cause
Action
Error group 31 I²t monitoring
No. Code Message
31-0 2312h I²t error motor (I²t at 100 %)
Cause
Action
31-1 I²t error controller (I²t at 100 %)
2311h
Cause
Action
Error group 32 Intermediate circuit
No. Code Message
32-0 3280h Intermediate circuit charging time exceeded
Cause
Action
32-8 3285h Power supply failure during controller enable
Cause
Action
Festo – GDCP-CMMS/D-C-CO-EN – 1404NH – English
– Checksum incorrect.
– File not present.
– File format incorrect.
– Error backing up the parameter file on the SD card.
• Check content (data) of the SD card.
I²t monitoring of the controller has been triggered.
– Motor/mechanical system blocked or sluggish.
– Motor under-sized?
• Check motor and mechanical system.
I²t monitoring of the controller has been triggered.
• Check power dimensioning of drive package.
Only CMMS-AS/CMMD-AS:
The intermediate circuit could not be charged after the mains
voltage was applied.
– Fuse possibly defective.
– Internal braking resistor defective.
– In operation with external braking resistor, the resistor is not
connected
• Check mains voltage (intermediate circuit voltage < 150 V)
• Check interface to the external braking resistor.
• If the interface is correct, the internal braking resistor or the
built-in fuse is presumably faulty
Interruption/power failure while the controller enable was active.
• Check mains voltage/power supply.
Reaction
configurable
Reaction
configurable
configurable
Reaction
PS off
Repair by the manufacturer.
PS off
149