Software Versions; Thermistor Reset; Reset Thermal Model - Danfoss VLT MCD 600 Operating Manual

Operating Guide | VLT® Soft Starter MCD 600
The bottom line of the screen shows the model number.
Serial Number & Rating
MCD 600
123456-123
0410-T5-S1-CV2
Illustration 17: Serial Number & Rating Screen

6.13 Software Versions

The software version screen reports the version of each software component of the soft starter:
• User interface.
• Motor control.
• Remote LCP (if connected).
• Parameter list.
• Bootloader.
• Expansion card (if fitted).
Updated software, including alternative languages, can be loaded into the soft starter via the USB port if required. Contact the
local supplier for further information.

6.14 Thermistor Reset

The thermistor input is disabled by default, but activates automatically when a thermistor is detected. If thermistors have previously
been connected to the soft starter but are no longer required, use the thermistor reset function to disable the thermistor.

6.15 Reset Thermal Model

The thermal modeling software in the soft starter constantly monitors the motor performance. This allows the soft starter to calculate
the motor temperature and ability to start successfully at any time.
The thermal model can be reset if required.
REDUCED MOTOR LIFETIME
Resetting the motor thermal model compromises thermal model protection and may compromise motor life.
Only reset the thermal model in an emergency.
-
46 | Danfoss A/S © 2018.10
N O T I C E
N O T I C E
Set-up Tools
AQ262141844215en-000202 / 175R1174