Danfoss VLT MCD 600 Operating Manual page 78

Operating Guide | VLT® Soft Starter MCD 600
Option Function
Smart card + The soft starter accepts start commands from the smart card if they are within the operating schedule set in
clock parameters 4-1 to 4-24. A stop command from the smart card is accepted regardless of the schedule.
Timer After a start signal is received, the soft starter starts and stops the motor according to the timers set in pa-
rameter 4-2 Run Time and parameter 4-3 Stopped Time.
Table 21: 1-2 Motor Full Load Current
Range Function
Model dependent Matches the soft starter to the FLC of the motor. Set to the FLC rating shown on the motor nameplate.
Table 22: 1-3 Motor kW
Range Function
*0 0–9999 kW Sets the running power of the connected motor in kW. This setting is the basis for power reporting and protec-
tion.
Table 23: 1-4 Locked Rotor Time
Range
*10 s 0:01–2:00 (mi-
nutes:seconds)
Table 24: 1-5 Locked Rotor Current
Range
*600% 400–1200% FLC
Table 25: 1-6 Motor Service Factor
Range Function
*105% 100– Sets the motor service factor used by the thermal model. If the motor runs at full load current, it reaches 100%.
130% Set according to the motor datasheet.
Parameters 1-4 to 1-6 determine the trip current for motor overload protection. The default settings of
parameters 1-4 to 1-6 provide motor overload protection: Class 10, trip current 105% of FLA (full load
amperage) or equivalent.
Table 26: 1-7 Reserved
Range Function
This parameter is reserved for future use.
78 | Danfoss A/S © 2018.10
Function
Sets the maximum length of time the motor can sustain locked rotor current from cold before
reaching its maximum temperature. Set according to the motor datasheet.
Function
Sets the locked rotor current of the connected motor as a percentage of full load current. Set according
to the motor datasheet.
N O T I C E
Programmable Parameters
AQ262141844215en-000202 / 175R1174