Danfoss VLT MCD 600 Operating Manual page 11

Operating Guide | VLT® Soft Starter MCD 600
SAFETY OF PERSONNEL
The soft starter is not a safety device and does not provide electrical isolation or disconnection from the supply.
If isolation is required, the soft starter must be installed with a main contactor.
-
Do not rely on the start and stop functions for safety of personnel. Faults occurring in the mains supply, the motor
-
connection, or the electronics of the soft starter can cause motor starts or stops.
If faults occur in the electronics of the soft starter, a stopped motor may start. A temporary fault in the mains supply or loss
-
of motor connection can also cause a stopped motor to start.
To provide safety of personnel and equipment, control the isolation device through an external safety system.
-
Before changing any parameter settings, save the current parameter set to a file using MCD PC Software or the Save User
-
Set function.
Use the Auto-start feature with caution. Read all the notes related to auto-start before operation.
-
Disclaimer
The examples and diagrams in this manual are included solely for illustrative purposes. The information contained in this manual is
subject to change at any time and without prior notice. Responsibility or liability is never accepted for direct, indirect, or consequential
damage resulting from the use or application of this equipment.
Danfoss A/S © 2018.10
W A R N I N G
N O T I C E
N O T I C E
AQ262141844215en-000202 / 175R1174 | 11
Safety