Parameter Group 31-** Flow Protection - Danfoss VLT MCD 600 Operating Manual

Operating Guide | VLT® Soft Starter MCD 600
Table 209: 30-12 - Depth Sensor Type
Option Function
Selects which type of sensor is associated with the depth sensor input on the smart card.
* None
Switch
Analog
Table 210: 30-13 - Depth Units
Option Function
Selects which units the sensor uses to report the measured depth.
* meters
feet
Table 211: 30-14 - Depth at 4 mA
Range Function
*0 0–1000 Calibrates the soft starter to the 4 mA (0%) level of the depth sensor input.
Table 212: 30-15 - Depth at 20 mA
Range Function
*0 0–1000 Calibrates the soft starter to the 20 mA (100%) level of the depth sensor input.

10.19 Parameter Group 31-** Flow Protection

The parameters in this group are only active if a smart card is installed.
Flow protection uses termianls B33, B34 or C23, C24 on the smart card.
Table 213: 31-1 - High Flow Trip Level
Range
*10 0–5000
Table 214: 31-2 - Low Flow Trip Level
Range
* 5 1–5000
Danfoss A/S © 2018.10
N O T I C E
Function
Sets the trip point for high flow protection.
Function
Sets the trip point for low flow protection.
Programmable Parameters
AQ262141844215en-000202 / 175R1174 | 113