Programmable Parameters; Main Menu; Changing Parameter Values; Adjustment Lock - Danfoss VLT MCD 600 Operating Manual

Operating Guide | VLT® Soft Starter MCD 600

10 Programmable Parameters

10.1 Main Menu

Use the Main Menu to view and change programmable parameters that control how the soft starter operates.
To open the Main Menu, press [Main Menu] while viewing the monitoring screens.

10.2 Changing Parameter Values

Procedure
1. Scroll to the parameter in the Main Menu.
2. Press [Menu/Store] to enter edit mode.
3. Press [▵] or [▿] to change parameter settings.
Pressing [▵] or [▿] once increases or decreases the value by 1 unit. If the key is held for longer than 5 s, the value increases or
decreases at a faster rate.
Press [Store] to save changes. The setting shown on the display is saved and the LCP returns to the parameter list.
Press [Back] to cancel changes. The LCP asks for confirmation, then returns to the parameter list without saving the changes.

10.3 Adjustment Lock

Use parameter 10-7 Adjustment Lock to prevent users from changing parameter settings.
If a user attempts to change a parameter value when the adjustment lock is active, the following error is shown: Access Denied. Adj Lock
is On.

10.4 Parameter List

Table 19: Parameter List
Parameter group number
1
1-1
1-2
1-3
1-4
1-5
1-6
1-7
2
2-1
2-2
70 | Danfoss A/S © 2018.10
Parameter group name
Motor Details
Command Source
Motor Full Load Current
Motor kW
Locked Rotor Time
Locked Rotor Current
Motor Service Factor
Reserved
Motor Start/Stop
Start Mode
Start Ramp Time
Programmable Parameters
Default setting
Digital Input
Model dependent
0 kW
00:10 (mm:ss)
600%
105%
–
Constant Current
00:10 (mm:ss)
AQ262141844215en-000202 / 175R1174