Parameter Group 6-** Protection Action - Danfoss VLT MCD 600 Operating Manual

Operating Guide | VLT® Soft Starter MCD 600

10.10 Parameter Group 6-** Protection Action

Table 106: 6-1 - Auto-Reset Count
Range Function
*0 0–5 Sets how many times the soft starter auto-resets if it continues to trip.
The reset counter increases by 1 each time the soft starter auto-resets, and resets after a successful start.
Setting this parameter to 0 disables auto-reset.
Table 107: 6-2 - Auto-Reset Delay
Range
*5 s 0:05–15:00 (minutes:seconds)
Table 108: 6-3 - Current Imbalance
Option Function
Selects the soft starter's response to each protection.
All protection events are written to the event log.
* Soft Trip and The soft starter stops the motor as selected in parameter 2-9 Stop Mode or parameter 3-11 Stop Mode, then
Log enters trip state. The trip must be reset before the soft starter can restart.
Soft Trip and The soft starter stops the motor as selected in parameter 2-9 Stop Mode or parameter 3-11 Stop Mode, then
Reset enters trip state. The trip resets after the auto-reset delay.
Trip Starter The soft starter removes power and the motor coasts to stop. The trip must be reset before the soft starter
can restart.
Trip and Reset The soft starter removes power and the motor coasts to stop. The trip resets after the auto-reset delay.
Warn and Log The protection is written to the event log and the display shows a warning message, but the soft starter con-
tinues to operate.
Log Only The protection is written to the event log but the soft starter continues to operate.
Table 109: 6-4 - Undercurrent
Option
* Soft Trip and Log
Soft Trip and Reset
Trip Starter
Trip and Reset
Warn and Log
Log Only
Danfoss A/S © 2018.10
Function
Sets a delay before the soft starter auto-resets a trip.
Function
Selects the soft starter's response to the protection event.
Programmable Parameters
AQ262141844215en-000202 / 175R1174 | 91