Installing The 2-Pedal Foot Switch (Option) - Brother KE-430HX Service Manual

11. INSTALLING THE 2-PEDAL FOOT SWITCH (OPTION)

11. INSTALLING THE 2-PEDAL FOOT SWITCH (OPTION)
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the control box cover. Touching areas where high voltages are present will result in serious injury
from electric shocks.
Be sure to connect the ground.
If the ground connection is not secure, you run a high risk of serious injury from electric shocks, and problems with
correct operation will also occur.
No. 2-pedal foot switch
7P connector
1 Start
2 0V
3 Clamp
4 0V
5 Option
6 0V
7 -
1. Insert the connector (1) of the 2-pedal foot switch into connector <P10> on the main PCB.
2. Temporarily remove the two screws (2) from the ground terminal of the control box, and then connect the two ground wires
(3) in the 2-pedal foot switch harness to the ground terminal and retighten the screws to the ground terminal.
3. Close the cord presser plate (4) in the direction of the arrow, and secure it by tightening the two screws (5).
NOTE:
・ Make sure that the ground connections are secure in order to ensure safety.
・ Close the cord presser plate (4) securely so that no foreign objects, insects or small animals can get inside the control
box.
165
DANGER
KE-430HX/KE-430HS, BE-438HX/BE-438HS
4055B