Work Clamp Lifter Mechanism - Brother KE-430HX Service Manual

Electronic direct drive lockstitch bar tacker electronic direct drive lockstitch button sewer
Hide thumbs Also See for KE-430HX:
Table of Contents

Advertisement

8. ASSEMBLY

8-7. Work clamp lifter mechanism

Apply grease to the portions indicated by the white arrows.
* Refer to the next page for the points to note during reassembly.
Set so that the worn surface is on the inside, and align with the
screw stop. Tighten the two set screws 9 so that there is no
play in the axial direction. Check that the W-clamp cam shaft 6
rotates smoothly.
C on next page
A on next page
1. Spring hook
2. Bolts [2 pcs]
3. Springs [2 pcs]
4. Cam gear
5. Thread wiper cam
6. W-clamp cam shaft
7. Set screws [4 pcs: Tighten]
8. Set screw collar
111
A on next page
9. Set screws [2 pcs: Tighten]
10. Plain washers [2 pcs]
11. Thread wiper driving lever
12. Drive lever w-clamp lifter
13. Lever shaft
14. Retaining ring E
15. Set screws [2 pcs: Tighten]
16. Gear 16
KE-430HX/KE-430HS, BE-438HX/BE-438HS
D on next page
B, D on next page
17. Pulse motor P assembly
18. Set screws [2 pcs: Tighten]
19. Bolts [4 pcs]
20. Motor bracket assembly
21. Bolts [3 pcs]
22. Link shoulder screw
B on next page
C, D on next page
4019B
(Continued on next page.)

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Ke-430hsBe-438hsBe-438hx

Table of Contents