Thread Nipper Mechanism (Ke-430Hx-03, -0K, -01 Specifications Only) - Brother KE-430HX Service Manual

8-6. Thread nipper mechanism (KE-430HX-03, -0K, -01 specifications only)

Apply grease to the portions indicated by the white arrows.
Adjust while referring to "9-21. Adjusting the
thread nipper motor position".
Small amount
Small amount
Install so that the pin of the arm goes
into the open part of the slot in the
TN-connecting plate F assembly 11.
1. Spring hook plate
2. Plain washers [2 pcs]
3. Screws [2 pcs]
4. Spring extension
5. Thread nipper U
6. Shoulder screw, 6-0.9
Small amount
Small amount
7. Thread nipper spacer
8. Thread nipper collar
9. Thread nipper D assembly
10. Thread nipper shoulder screw
11. TN-connecting plate F assembly
12. TN-connecting plate R
KE-430HX/KE-430HS, BE-438HX/BE-438HS
The TN-driving lever 14 and the washer 15 which are
marked with * should be installed at the time of
installation of the thread trimmer mechanism.
13. Bolts [2 pcs]
14. TN-driving lever
*
15. Washer
*
16. Washer, wave spring
17. Link shoulder screw
18. TN-driving lever spring
8. ASSEMBLY
4018B
110