Brother KE-430HX Service Manual page 160

9. ADJUSTMENT
5
Home position
For example, if the offset value is 10
6
(3)
7 Repeat steps 5 and 6 to set the home position to the correct position.
Completion of setting
8
149
3950B
(1)
(2)
(5)
KE-430HX/KE-430HS, BE-438HX/BE-438HS
Use the feed plate and press the
change the offset value so that the needle drops at the
home position.
・ The X-feed or Y-feed motor will operate according to
the offset value.
・ The offset value will flash after it has been changed.
・ The offset value to be changed can be switched
between the value for the X motor (1), Y motor (2) and
work clamp motor (5) at any time simply by touching
the value.
Touch the check key
the offset value.
・ Home position detection for the feed motor will be
carried out based on the currently-displayed offset
value. Check the home position.
Touch the OK key
・ The changed offset value will stop flashing and will be
illuminated on the screen.
* If the offset value has not been provisionally confirmed
(if the check key was not touched), the invalid buzzer
will sound.
When the setting has been completed, press the back key
.
・ The display will return to the adjustment menu screen.
or
(3) to provisionally confirm
to confirm the offset value.
key to