Installing The Air Unit And Valve Unit; Installing The 2-Pedal Foot Switch (When Using The 2-Pedal Foot Switch) - Brother RH-9820 Instruction Manual

3-10. Installing the air unit and valve unit

3-11. Installing the 2-pedal foot switch (when using the 2-pedal foot switch)

0358B
(1) 2-pedal foot switch
(2) Foot switch conversion harness
Pass the connector of the foot switch conversion harness (2)
into the control box through the hole in the rear of the control
box. (Refer to "3-8. Installing the operation panel".)
<2-pedal foot switch operation method>
When the work clamp switch (left side) is depressed, the
work clamp will be lowered, and when the start switch (right
side) is depressed, the sewing machine will start.
Work clamp switch
0361B
RH-9820
3. INSTALLATION
Install to the underside of the table.
(Refer to "3-1. Table processing
diagram" for the installation positions.)
(1) Air unit
(2) Screws [2 pcs.]
(3) Valve unit
(4) Screws [2 pcs.]
(5) Air tube No. 4
Insert air tube No. 4 (5) into the joint (6)
and the joint (7).
NOTE:
•
Install the air unit (1) so that it does
not touch the table leg.
•
Be careful to avoid injury from items
such as sewing machine parts and
the corners of table drawers during
installation.
Start switch
4923Q
14