Brother KE-430HX Service Manual page 137

KE-430HS, BE-438HX/BE-438HS
With the needle bar 17 near
its highest position, apply
grease inside the holes.
Align the needle bar 17 so that reference line A (the second
lowest reference line on the needle bar 17) or reference line a
(top reference line) is aligned with the lower edge of the needle
bar bush when the machine pulley is turned to lower the needle
bar 17 to its lowest position, and then set the cut section so that it
is facing forward and tighten the screw 18.
4647Q
Cut section
KE-430HX/KE-430HS, BE-438HX/BE-438HS
8. ASSEMBLY
16. Needle bar clamp
17. Needle bar [Insert from above]
18. Screw
19. Wick holder
20. Screw
21. Rubber cap
22. Cord holder
23. Screw
24. Needle bar thread guide
25. Needle
26. Screw
4074B
Needle bar bush
126