Watchdog Timer; Fig. 20 Watchdog Timer Function; Fig. 21 Program Example To Enter The Ram Back-Up Mode When Using The Watchdog Timer - Renesas 4513 User Manual

WATCHDOG TIMER

Watchdog timer provides a method to reset the system when a pro-
gram runs wild. Watchdog timer consists of a 16-bit timer (WDT),
watchdog timer enable flag (WEF), and watchdog timer flags
(WDF1, WDF2).
The timer WDT downcounts the instruction clocks as the count
source. The underflow signal is generated when the count value
reaches "0000 ." This underflow signal can be used as the timer 2
16
count source.
When the WRST instruction is executed after system is released
from reset, the WEF flag is set to "1". At this time, the watchdog
timer starts operating.
The value of timer (WDT)

Fig. 20 Watchdog timer function

The contents of WEF, WDF1 and WDF2 flags and timer WDT are
initialized at the RAM back-up mode.
If WDF2 flag is set to "1" at the same time that the microcomputer
enters the RAM back-up state, system reset may be performed.
When using the watchdog timer and the RAM back-up mode, ini-
tialize the WDF1 flag with the WRST instruction just before the
microcomputer enters the RAM back-up state (refer to Figure 21)
FFFF
16
0000
16
WEF flag
WDF1 flag
WDF2 flag
RESET pin output
4513/4514 Group User's Manual
FUNCTION BLOCK OPERATIONS
When the count value of timer WDT reaches "BFFF
the WDF1 flag is set to "1." If the WRST instruction is never ex-
ecuted while timer WDT counts 32767, WDF2 flag is set to "1," and
the RESET pin outputs "L" level to reset the microcomputer. Ex-
ecute the WRST instruction at each period of 32766 machine cycle
or less by software when using watchdog timer to keep the micro-
computer operating normally.
To prevent the WDT stopping in the event of misoperation, WEF
flag is designed not to initialize once the WRST instruction has
been executed. Note also that, if the WRST instruction is never ex-
ecuted, the watchdog timer does not start.
WRST
WRST
instruction
instruction
executed
executed
• •
•
•
•
•
WRST
EPOF
POF
Oscillation
stop
Fig. 21 Program example to enter the RAM back-up mode
when using the watchdog timer
HARDWARE
" or "3FFF
16
BFFF
16
3FFF
16
System reset
; WDF1 flag reset
; POF instruction enabled
(RAM back-up state)
,"
16
1-35