Table of Contents
Advertisement
2
Setting Up the Instrument
Setting Utility Parameters
Standby Mode
10
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
To set the date
1. Highlight Set Date and press Enter.
2. Press Set Date, type the date and press Enter.
3. Press Set Month, highlight the correct month and press Enter.
4. Press Set Year, type the year and then Enter.
5. Press Esc to save the settings.
To select the time format
You can set the instrument to display the time in either am/pm or 24-hour format. To change
the format, highlight Time Format and press Enter until the desired format (AM/PM or 24
hour) appears.
To set the time
1. Highlight Set Time and press Enter.
2. To set the hour, press Set Hour, type in the hour and press Enter.
3. To set the minutes, press Set Minute, type in the minute and press Enter.
4. To select between AM and PM (if in AM/PM time format), press Set AM/PM until the
appropriate setting appears.
Note Your changes are saved automatically (even during power down) by battery
backup.
To prolong lamp life, your spectrophotometer has been pre-set at the factory to automatically
go into standby mode after 15 minutes of inactivity.
Since the tungsten lamp of the Orion AquaMate Vis spectrophotometer requires a 30-minute
warm-up, the spectrophotometer has been pre-set at the factory to Standby Mode OFF.
To change Standby Mode time
1. Highlight Standby and press Enter.
Thermo Scientific
Hide quick links:
Advertisement
Table of Contents
