Deleting Wavelengths And Factors; Taking Measurements - Thermo Scientific Orion AquaMate 8000 UV-Vis User Manual

Deleting Wavelengths and Factors

Taking Measurements

Thermo Scientific
2. Highlight a position for entering the first wavelength and factor pair.
3. Press Add nm.
4. Enter the values for the wavelength and factor and press Enter.
5. When the values are correct, press Add nm.
6. Continue until you have entered all the wavelengths and factors.

To delete wavelengths and factors
1. Press Set nms.
Note If no wavelength values have been entered, the wavelength and factor columns
will be empty.
2. Highlight the first wavelength and factor pair to delete.
3. Press Delete nm.
You can access Multiwavelength acquisition from either the Set nms screen shown above or
from the Multiwavelength setup screen.
 To take measurements automatically (Auto 6 or Auto 3)
1. Press Run Test to display the Multiwavelength measurement screen.
Orion AquaMate 7000 Vis and Orion AquaMate 8000 UV-Vis
16
Multiwavelength
Taking Measurements
77